-
181
-
182
High‐Efficiency Flexible GaAs/InGaAs Dual‐Junction Solar Cells Fabricated by Metallic Nanoparticle‐Based Wafer Bonding
Published 2025-02-01“…Under 1 sun AM 1.5G illumination, a high power conversion efficiency of 28.5% is achieved for the two‐terminal series‐connected dual‐junction cell, with an average external radiative efficiency of 2.6%. …”
Get full text
Article -
183
LPV Control for the Full Region Operation of a Wind Turbine Integrated with Synchronous Generator
Published 2015-01-01“…Wind turbine conversion systems require feedback control to achieve reliable wind turbine operation and stable current supply. …”
Get full text
Article -
184
Modeling and Optimization of the BSCF-Based Single-Chamber Solid Oxide Fuel Cell by Artificial Neural Network and Genetic Algorithm
Published 2019-01-01“…The optimum conditions to achieve maximum power of the cell were then determined by the genetic algorithm and the developed ANN.…”
Get full text
Article -
185
A Study of Supplier Selection Method Based on SVM for Weighting Expert Evaluation
Published 2021-01-01Get full text
Article -
186
Ultra-Low-Voltage CMOS-Based Current Bleeding Mixer with High LO-RF Isolation
Published 2014-01-01Get full text
Article -
187
Enhancing heat recovery efficiency in chimney exhaust systems using thermoelectric generators – Thermal modeling and parametric analysis
Published 2025-04-01“…Performance metrics demonstrate that the positioning of the thermoelectric generator site can bring about major improvements including thermal resistance, generated power, temperature of water heated, and energy conversion efficiency, which ranged from 0.57 % to 5.6 %, depending on thermoelectric generators configuration and operating parameters. …”
Get full text
Article -
188
Exergy, Energy, and Dynamic Parameter Analysis of Indigenously Developed Low-Concentration Photovoltaic System
Published 2013-01-01“…Short-circuit current shows increasing trend with increasing input exergy rate of ≈0.011 A/W. Power conversion efficiency decreases from 7.07 to 5.66%, and open-circuit voltage decreases from 9.86 to 8.24 V with temperature coefficient of voltage ≈-0.021 V/K under ATC. …”
Get full text
Article -
189
The van der Waals heterostructures of blue phosphorene with GaN/GeC for high-performance thermoelectric applications
Published 2025-01-01“…Thermoelectric devices have substantial potential as an environmentally compatible and sustainable power source to produce electricity straight out of waste heat. …”
Get full text
Article -
190
Modeling and Assessment of a Biomass Gasification Integrated System for Multigeneration Purpose
Published 2016-01-01“…This paper focuses on the accurate modeling of biomass gasification process and the optimal design of a multigeneration system (heating, cooling, electrical power, and hydrogen as energy carrier) to take the advantage of this clean energy. …”
Get full text
Article -
191
Effect of Multilayers CdS Nanocrystalline Thin Films on the Performance of Dye-Sensitized Solar Cells
Published 2023-01-01Get full text
Article -
192
Interconnected TiO2 Nanowire Networks for PbS Quantum Dot Solar Cell Applications
Published 2012-01-01Get full text
Article -
193
-
194
Enhancing CsSn0.5Ge0.5I3 Perovskite Solar Cell Performance via Cu2O Hole Transport Layer Integration
Published 2024-01-01Get full text
Article -
195
Improving the Hybrid Photovoltaic/Thermal System Performance Using Water-Cooling Technique and Zn-H2O Nanofluid
Published 2017-01-01“…The experimental results showed that the increase in output power is achieved. It was found that, without any cooling, the measuring of the PV temperature was 76°C in 12 June 2016; therefore, the conversion efficiency does not exceed more than 5.5%. …”
Get full text
Article -
196
The State-of-the-Art Brief Review on Piezoelectric Energy Harvesting from Flow-Induced Vibration
Published 2021-01-01“…Nevertheless, such fluid-structure coupling process continuously extracts the kinetic energy from ambient fluid flow, presenting the conversion potential from the mechanical energy to electricity. …”
Get full text
Article -
197
Biotemplated Synthesis of Titanium Oxide Nanoparticles in the Presence of Root Extract of Kniphofia schemperi and Its Application for Dye Sensitized Solar Cells
Published 2021-01-01“…Biosynthesized TiO2 NPs were used as photoanode in dye-sensitized solar cells (a device used for converting absorbed light into electricity). Solar cell devices were fabricated using roots of Kniphofia schemperi sensitizer in the presence of TiO2 NPs biosynthesized within (2 : 3, 1 : 1, and 3 : 2) volume ratio, which showed power conversion efficiency of 0.039%, 0.117%, and 1.3%. …”
Get full text
Article -
198
Simulation and analysis of ZnO/SWCNT solar cell using the SCAPS-1D program
Published 2025-01-01“…The ZnO/SWCNT solar cell demonstrates impressive power conversion efficiency (η = 24.42 %), an open-circuit voltage (Voc) of 0.7740 V, a short-circuit current density (Jsc) of 40.303777 mA/cm2, and a fill factor (FF) of 78.27 %. …”
Get full text
Article -
199
-
200
Design and Simulation of an Environment-Friendly ZrS2/CuInS2 Thin Film Solar Cell Using SCAPS 1D Software
Published 2023-01-01Get full text
Article