-
21
-
22
-
23
Failure analysis and size optimization of CFRP composite single-lap bonded joints based on the influence of multiple parameters
Published 2024-12-01Subjects: “…Composite laminates…”
Get full text
Article -
24
A Fatal Case of COVID-19 in an Infant with Severe Acute Malnutrition Admitted to a Paediatric Ward in Niger
Published 2020-01-01Get full text
Article -
25
Fractal Dimension-Based Damage Imaging for Composites
Published 2013-01-01“…Experimental investigation in a composite laminate and a stiffened composite panel shows that the developed algorithm could quantitatively predict the location and size of not only single but also multiple damages. …”
Get full text
Article -
26
Anticardiolipin Autoantibodies as Useful Biomarkers for the Prediction of Mortality in Septic Patients
Published 2022-01-01Get full text
Article -
27
Post- Impact Fatigue Damage Analysis of Quasi Isotropic
Published 2019-07-01“…The cooling response obtained when the impact damage as well as heating was on the rear surface provided a good correlation with the damage volume quantified through X-ray CT image processing. …”
Get full text
Article -
28
Computed Tomography analysis of damage in composites subjected to impact loading
Published 2013-04-01“…The failure mode and the internal damage of the impacted composites have been, also, investigated using 3D Computed Tomography.…”
Get full text
Article -
29
Sensitivity-enhancing feedback control–based damage detection in delaminated smart composite plates
Published 2019-07-01“…In this article, we present a sensitivity-enhancing feedback control–based damage detection method for piezoelectric actuator and sensor bonded composite laminates with delamination failures. …”
Get full text
Article -
30
FAILURE ANALYSIS AND EXPERIMENTAL STUDY OF COMPOSITE MULTI-PIN CONNECTIONS BASED ON CONTINUUM DAMAGE MECHANICS
Published 2022-01-01“…In this paper, numerical analysis and experimental study on the failure and damage of composite multi-pin connection structure under tensile load are carried out. …”
Get full text
Article -
31
Composites in high-pressure hydrogen storage: A review of multiscale characterization and mechanical behavior
Published 2025-03-01“…However, the refueling of high-pressure hydrogen tanks can lead to a rapid increase in the internal temperature of the storage cylinder, potentially causing a decrease in the state of charge, damage to tank walls, and, ultimately, safety concerns. …”
Get full text
Article -
32
Novel 2D strain-rate-dependent lamina-based and RVE/phase-based progressive fatigue damage criteria for randomly loaded multi-layer fiber-reinforced composites
Published 2022-01-01“…Two implicit progressive fatigue damage models that rely on new equivalent-damage and equivalent-stress criteria are presented for the prediction of various failure modes of the composites. …”
Get full text
Article -
33
Toughening of thermoset composites using glass/polypropylene commingled stitching yarns
Published 2025-01-01“…This paper investigates the damage resistance and tolerance of thermoset composite laminates stitched by glass and hybrid glass/polypropylene commingled yarns. …”
Get full text
Article -
34
MULTI-SCALE ANALYSIS OF CRYOGENIC COMPOSITE STRUCTURES CONSIDERING INTERFACIAL PHASE
Published 2021-01-01“…In this paper, a multi-scale finite element method is proposed based on three-phase representative volume element, by developing the microscopic failure criterion, damage degradation model and uncertainty model of material strength. …”
Get full text
Article -
35
Residual stresses caused by static and dynamic contact interaction of composite plate and steel spherical indenter
Published 2025-01-01“…The presented studies were carried out both for static and dynamic application of contact indentation of a spherical indenter into a flat surface of samples made of laminated carbon fiber material with cross-ply stacking sequence. …”
Get full text
Article -
36
Microstructure evolution and mechanical properties of ZK61 magnesium alloy fabricated via friction stir additive manufacturing
Published 2025-01-01“…In this study, a high-strength laminated block of ZK61 Mg alloy was fabricated by the FSAM process. …”
Get full text
Article