Showing 501 - 520 results of 2,631 for search 'AC Carpi~', query time: 1.89s Refine Results
  1. 501

    Effect of Preparation Conditions of Fe@SiO<sub>2</sub> Catalyst on Its Structure Using High-Pressure Activity Studies in a 3D-Printed SS Microreactor by Meric Arslan, Sujoy Bepari, Juvairia Shajahan, Saif Hassan, Debasish Kuila

    Published 2025-01-01
    “…The catalysts were prepared by two different techniques: one pot (OP) and autoclave (AC). The mesoporous structure of the two catalysts, Fe@SiO<sub>2</sub> (OP) and Fe@SiO<sub>2</sub> (AC), ensured a large contact area between the reactants and the catalyst. …”
    Get full text
    Article
  2. 502

    Design and Construction of Underground Cable Fault Location and Notification System. by Mugisha, Simon

    Published 2023
    “…In determining the location of a fault point in the underground cable, the AC power in the cables is first switched off because they cannot carry both AC power and DC power at once and the standard concept of Ohms law is applied that is, when a low DC voltage is applied at the feeder end through a series resistors representing the cable lines, then current would vary depending upon the location of the fault point in the cable. …”
    Get full text
    Thesis
  3. 503
  4. 504

    Stability analysis of a numerical method for the 3D high-order Allen–Cahn equation by Seokjun Ham, Jyoti, Jaeyong Choi, Yunjae Nam, Junseok Kim

    Published 2025-01-01
    “…The Allen–Cahn (AC) equation describes how phase separation occurs in binary alloy systems and the dynamics of interfaces between different phases. …”
    Get full text
    Article
  5. 505

    An Investigation of the Electrical Properties of Pressboard Impregnated with Mineral Oil-Based Nanofluids at Different Concentrations of Fe3O4 Magnetic Nanoparticles by Pichai Muangpratoom, Issaraporn Khonchaiyaphum, Wanwilai Vittayakorn

    Published 2022-01-01
    “…The electrical tests were performed on the AC breakdown strengths and positive-negative lightning impulse breakdown strengths on impregnated pressboard were carried out in compliance with IEC 60641 and IEC 60243, respectively. …”
    Get full text
    Article
  6. 506

    Optimization of Abrasive Wear Characteristics of Polyethylene/Acrylate Copolymer Nanocomposites by S. Chockalingam, G. Gopalarama Subramaniyan, Anand Bisen, S. Kaliappan, S. Sekar, Pravin P. Patil, T. Ch. Anil Kumar, B. Ramesh, S. Venkatesan

    Published 2022-01-01
    “…As the compatibilizer, Elvaloy-AC-3427 (EAC) was used in addition to Cloisite 30B (C3B) as the reinforcement of filler in this research. …”
    Get full text
    Article
  7. 507
  8. 508
  9. 509
  10. 510

    A Decontamination Process to Remove Metals and Stabilise Montreal Sewage Sludge by G. Mercier, J.F. Blais, F. Hammy, M. Lounes, J.L. Sasseville

    Published 2002-01-01
    “…Verification of the application of METIX-AC technology was carried out in a pilot plant set up near the sludge production plant of the MUC. …”
    Get full text
    Article
  11. 511
  12. 512
  13. 513
  14. 514
  15. 515

    Desired Compensation Adaptive Robust Control of an Active Vibration Isolation System by Bo Zhao, Weijia Shi, Ming Zhang, Jiaxin Li, Feng Li

    Published 2018-01-01
    “…The numerical simulation and comparative experiments are carried out under the conditions of using DCARC, DRC, and AC controllers. …”
    Get full text
    Article
  16. 516
  17. 517

    An Investigation of the Capabilities of Resin Tire Carbon Black “N-330” as a Waste Binder in Asphalt Concrete Mixtures by Amr. A. Nada, Walid Fouad Edris, Hebah Mohammad Al-Jabali, Ahmed D. Almutairi, Abd Al-Kader A. Al Sayed, Shady Khairy

    Published 2025-01-01
    “…Moreover, these samples outperformed asphalt mixtures using bitumen as the binder in terms of stability. Also, the AC-B mixes exhibited lower flow values compared to the AC-RTCB mixes. …”
    Get full text
    Article
  18. 518
  19. 519
  20. 520