-
1
A Joint Optimization Method for Power and Array of Multi-Point Sources System
Published 2025-07-01“…Therefore, in order to achieve an optimal balance between the two, this paper proposes a joint optimization method for jamming power and an array of multi-point source systems. …”
Get full text
Article -
2
Optimizing the hydroxyapatite nanocrystals derived from biological sources to increasing efficiency and quality
Published 2024-11-01“…The purpose of this study was to optimize hydroxyapatite nanocrystals prepared from biological sources with higher efficiency and quality. …”
Get full text
Article -
3
ANALYSIS METHOD AND PROCESS OPTIMIZATION OF VIBRATION SIGNAL IN PRECISION MILLING BASED ON BLIND SOURCE SEPARATION
Published 2022-01-01Subjects: Get full text
Article -
4
Fields2Benchmark: An open-source benchmark for coverage path planning methods in agriculture
Published 2025-12-01Get full text
Article -
5
Study on the Defrosting Control Method Based on the Optimal Average Performance of an Air Source Heat Pump
Published 2016-01-01“…A defrosting control method based on the optimal average performance of an air source heat pump (ASHP) unit is presented. …”
Get full text
Article -
6
-
7
Optimized decomposition and identification method for multiple power quality disturbances
Published 2024-11-01Get full text
Article -
8
A Review of Inertia Prediction Methods for Power System with High Penetration Renewable Energy Sources
Published 2025-08-01Get full text
Article -
9
Collaborating Filtering Method Based on Multiple Data Sources
Published 2015-07-01Get full text
Article -
10
-
11
A stochastic optimization method for economic microgrid operation based on "source-load operation" mode classification
Published 2025-06-01“…To address this issue, an economic operation decision-making method for microgrids based on source-load operation mode classification is proposed to achieve economic operation under uncertain conditions. …”
Get full text
Article -
12
A Comparison of Inversion Methods for Surrogate‐Based Groundwater Contamination Source Identification With Varying Degrees of Model Complexity
Published 2024-04-01“…Currently, the methods for identifying contamination sources mainly fall into three distinct categories: simulation optimization, Bayesian inference, and data assimilation. …”
Get full text
Article -
13
Advances in Multi-Source Navigation Data Fusion Processing Methods
Published 2025-04-01“…Additionally, methods based on Factor Graph Optimization (FGO) have also demonstrated advantages in multi-source data fusion, offering better handling of global consistency problems. …”
Get full text
Article -
14
A Reactive Power Partitioning Method Considering Source–Load Correlation and Regional Coupling Degrees
Published 2025-04-01“…To address the enhanced coupling characteristics in reactive power partitioning of power grids with high-penetration renewable energy integration, this paper proposes an optimized reactive power partitioning method that integrates dynamic source–load correlation characteristics and regional coupling degree evaluation. …”
Get full text
Article -
15
-
16
Convolutive blind source separation method based on tensor decomposition
Published 2021-08-01“…A convolutive blind source separation algorithm was proposed based on tensor decomposition framework, to address the estimation of mixed filter matrix and the permutation alignment of frequency bin simultaneously.Firstly, the tensor models at all frequency bins were constructed according to the estimated autocorrelation matrix of the observed signals.Secondly, the factor matrix corresponding to each frequency bin was calculated by tensor decomposition technique as the estimated mixed filter matrix for that bin.Finally, a global optimal permutation strategy with power ratio as the permutation alignment measure was adopted to eliminate the permutation ambiguity in all the frequency bins.Experimental results demonstrate that the proposed method achieves better separation performance than other existing algorithms when dealing with convolutive mixed speech under different simulation conditions.…”
Get full text
Article -
17
Optimized recovery method of wave field characteristics of tunnel drilling source of drilling jumbo and its engineering application
Published 2025-07-01“…This paper compares and analyzes the effect of time-domain cross-correlation in the wavelet transform domain through simulation, and concludes that the combination of the time–frequency cross-correlation in the wavelet transform domain, which excels in noise suppression and in the ability of extracting related information, and the algorithm of spike deconvolution. An optimized recovery method for the wavefield characteristics of drilling jumbo drilling source is implemented. …”
Get full text
Article -
18
-
19
Research on fault location method for micro-grid based on multi-source information fusion alarm
Published 2025-06-01Get full text
Article -
20