Search alternatives:
decrease » decreased (Expand Search)
Showing 301 - 320 results of 634 for search '(( increase reactions speed ) OR ((( decrease actions speed ) OR ( increased actions speed ))))', query time: 0.14s Refine Results
  1. 301

    Optical Study and Numerical Simulation of the Effect of n‐butanol Mass on the Combustion Process of a n‐butanol/Diesel Dual‐Fuel Engine by Wei Mingrui, Zhou Qian, Liu Jinping

    Published 2025-06-01
    “…This led to gradual increases in cylinder pressure and HRR. Emission analysis showed that n‐butanol introduction increased OH and HO2 radical concentrations, alongside elevated NOX and CO levels. …”
    Get full text
    Article
  2. 302

    A novel efficient route for removing Pb2+ ions from wastewater using 2-(4-nitrobenzylidene)malononitrile doped on Reed stems by Shahoo Ahmadi, Ghasem Marandi

    Published 2025-07-01
    “…Furthermore, this study evaluates the impact of various conditions, including temperature, pH, and solution stirring speed, on adsorption efficiency. The most favorable outcomes were observed at a neutral pH. …”
    Get full text
    Article
  3. 303

    The Influence of Selected Parameters of the Mathematical Model on the Simulation Performance of a Municipal Waste-to-Energy Plant Absorber by Michał Jurczyk, Marian Banaś, Tadeusz Pająk, Krzysztof Dziedzic, Bogusława Łapczyńska-Kordon, Marcin Jewiarz

    Published 2024-12-01
    “…The results will guide further research on the absorber. They will speed up and improve the modelling of chemical processes. …”
    Get full text
    Article
  4. 304

    Numerical analysis of electrochemically radiative and higher thermally conductive nanomaterials spinning motion due to rotating disk by Latif Ahmad, Umair Khan, Aisha M. Alqahtani, Marouan Kouki, Essam H. Ibrahim, Zuhaib Hamid, Saleem Javed

    Published 2025-04-01
    “…As the first-order reaction rate increases, the material concentration decreases, while radiation enhances the heat transfer rate. …”
    Get full text
    Article
  5. 305

    COMPARISON OF THE COMPRESSIVE STRENGTH OF CONVENTIONAL AND RESIN-MODIFIED GLASS IONOMER CEMENTS by Dushjanth Ganeshapooban, Saroash Shahid, Vesela Stefanova, Veselina Todorova

    Published 2024-11-01
    “…The specimens (after 24 hours and 28 days) were loaded in an Instron mechanical testing machine in compression until failure. A crosshead speed of 1mm/min and load cell of 30kN was used to conduct the compressive strength test. …”
    Get full text
    Article
  6. 306

    Relative Importance of Mode of Administration in Treatment Preferences among Plaque Psoriasis Patients in the United States by Steven R. Feldman, Anders Holmen Moeller, Sandra T. Erntoft Idemyr, Juan Marcos González

    Published 2016-08-01
    “…Improvements in treatment efficacy were more important than improvements in speed of onset and were more important than most increases in the chance of treatment side effects. …”
    Get full text
    Article
  7. 307

    Muscle Activity and Biomechanics of Sprinting: A Meta-Analysis Review by Przemysław Pietraszewski, Adam Maszczyk, Adam Zając, Artur Gołaś

    Published 2025-04-01
    “…., biceps femoris, semitendinosus, gluteus maximus) and biomechanical variables like step length, stride frequency, and ground reaction forces. Using random-effects models and meta-regression, the analysis revealed that increased sprint speed is associated with greater activation of the posterior thigh muscles and gluteus maximus. …”
    Get full text
    Article
  8. 308

    Operative Therapy Practices in Tubercular Patients with Bone and Joint Effects of Different Etiologies by G. S. Mukhamedjanov, R. A. Sharipov, H. K. Aminev, R. K. Yagafarova

    Published 2019-01-01
    “…A decrease in the number of patients with tuberculosis of the bone system coincides with an increase in the number of indications and methods for operational treatment. …”
    Get full text
    Article
  9. 309

    Investigation on Dynamic Factors of Railway Steel-Plate–Concrete Composite Beam Bridges With Small and Medium Spans by Jin Di, Yi Su, Yuxuan Han, Jinming Luo, Fengjiang Qin, Rui Yan

    Published 2024-01-01
    “…Resonance is produced when the train travel speed and bridge frequency meet a certain relationship, which in turn significantly increases the DF. …”
    Get full text
    Article
  10. 310

    A Hybrid Security Framework for Train-to-Ground (T2G) Communication Using DOA-Optimized BPNN Detection, Bayesian Risk Scoring, and RL-Based Response by Chaoyuan Sun, Weijiao Zhang, Peng Sun, Hui Wang, Chunhui Yang

    Published 2025-05-01
    “…With the widespread adoption of wireless communication technologies in modern high-speed rail systems, the Train-to-Ground (T2G) communication system for Electric/Diesel Multiple Units (EMU/DMU) has become essential for train operation monitoring and fault diagnosis. …”
    Get full text
    Article
  11. 311

    Assessment of mass characteristics of a wheeled chassis when designing a preventive suspension system by Malinovsky M.P., Tarichko V.I., Chikina A.K.

    Published 2025-06-01
    “…To achieve a preventive nature of the action by predicting longitudinal and lateral vibrations, brake pedal travel and fuel supply sensors, as well as a steering shaft speed sensor, are used. …”
    Get full text
    Article
  12. 312

    THE AERODYNAMIC CHRACTERISTICS CALCULATION METHODOLOGY OF TWO-SHELL PARAGLIDERS by V. V. Ovchinnicov, Yu. V. Petrov

    Published 2018-07-01
    “…A two-shell paraglider is a soft wing, the form of which is supported by the high-speed pressure in the stream and it is a complex aeroelastic system. …”
    Get full text
    Article
  13. 313

    DC Bus Overcurrent Protection Scheme in Metro DC Traction Power Supply System Based on Boolean Logic Calculation by LIU Yuxing, ZHENG Chunchun, LAI Peixin, XIE Jinlian, XIE Yuehai, LIU Yajie

    Published 2025-07-01
    “…It meets the requirements for protection reliability and speed, offering a DC bus protection solution that integrates low cost, high reliability, and simple implementation. …”
    Get full text
    Article
  14. 314

    Simulation of mixed flow characteristics of distiller′s grains-wastewater for anaerobic fermentation by Beibei YAN, Xiaoyun LIU, Shengquan ZHOU, Guanyi CHEN, Ziqiang ZHANG, Yonggang ZHANG

    Published 2024-12-01
    “…The simulation results showed that the slurry inside the curved blade at the top of the rotor reached a maximum velocity of 48.06 m/s and gradually decreased to zero along the radial direction. Due to the rotor's high-speed rotation, a high-pressure zone and a low-pressure zone were formed on each side of the rotor, with a maximum working pressure of 0.306 MPa. …”
    Get full text
    Article
  15. 315

    Improvement of management by training process of boxers at a stage of direct preparation for competitions by S.V. Kiprych, A.V. Donets, Omar Ali. Makhdi

    Published 2013-12-01
    “…The estimation of training impulse is conducted - integral index of reaction of the cardiorespiratory system. Trainings employments were standardized on duration (40 minutes) and orientation on development speed-power qualities, endurance. …”
    Get full text
    Article
  16. 316

    Formation of Orthogonal Components of Input Currents in Microprocessor Protections of Electrical Equipment by F. A. Romaniuk, Yu. V. Rumiantsev, V. Yu. Rumiantsev, I. V. Novash

    Published 2021-06-01
    “…With a strong saturation of the magnetic core of current transformers, the speed of obtaining reliable values of these components is increased by 1.5–2 times.…”
    Get full text
    Article
  17. 317

    A new process for extracting vanadium by direct calcification using the heat of molten vanadium slag by Qu J.-W., Zhang T.-A., Lv G.-Z., Chen Y.

    Published 2022-01-01
    “…Under the action of oxygen and CaO, the molten vanadium slag underwent calcification reaction to form acid-soluble calcium vanadate phase and the feasibility of its main chemical reaction was calculated by Factsage8.1. …”
    Get full text
    Article
  18. 318
  19. 319
  20. 320

    Dynamic interaction between the two-axle vehicle and continuous girder bridge with considering vehicle braking force by Nguyen Xuan Toan

    Published 2014-02-01
    “…The model of a two-axle vehicle consists of three masses, taking into account the inertia force and friction force between the tires and the bridge surface due to vehicle braking. Vertical reaction forces of axles which change with time make bending vibration of beam increase significantly. …”
    Get full text
    Article