The effect of biochar on enhancing soil fertility, mitigating soil salinity and promoting plant growth: a review by Abdul Hallim Majidi

“…Biochar (BC) is a widely recognized soil amendment, produced by pyrolysis from different biomass, its potential is determined through pyrolysis temperature and feedstock material. Biochar produced at maximum temperatures (> 500 ℃) increased bulk density and porosity to greater levels. …”
Get full text

RESEARCH ON PROPAGATION CHARACTERISTICS OF FATIGUE CRACK AND LIFE PREDICTION FOR THE PANTOGRAPH by JING SuoLi, JIA BuChao, YU YanZun, ZHOU Ning, LI Jing, LIU JiuRui, CHENG Yao

“…The fatigue crack propagation life under normal temperature,atmospheric environment and corrosion environment were predicted. …”
Get full text

Microstructure and Properties of Super-Ferritic Stainless Steels Used for Marine Construction after Fire Exposure by Ke-Yu Shen

“…After fire exposure, the mechanical properties and corrosion performance were affected based on the exposure temperature due to the precipitation of intermetallic compounds. …”
Get full text

Explanation of the Compensation Law and the Isokinetic Point in the Electrical Conduction of Crosslinked Polyethylene by Roger Walker, Eugene Furman, William H. Hunter Woodward, Michael Lanagan

“…This relationship is governed by the Meyer-Neldel temperature. However, there is no published evidence for a corresponding isokinetic point, a temperature where the conductivity of all LDPE samples is the same. …”
Get full text

Structural Parameters Optimization of Corona Ring of Tethered Balloon-Type VLF Antenna by Ao Wang, Xianqiang Li, Huajun Zhang, Ji Tian, Wenchuang Zhou

“…Due to dielectric loss, an abnormal temperature rise may occur at the antenna end, which may lead to an antenna fracture in serious cases. …”
Get full text

Fermion's Tunnelling with Effects of Quantum Gravity by Deyou Chen, Houwen Wu, Haitang Yang

“…It is of interest that, in our calculation, the quantum gravity correction decelerates the temperature increase during the radiation explicitly. …”
Get full text

Experimental investigation on the formation mechanism of the TiFe alloy by the molten-salt electrolytic titanium concentrate by Shi R., Bai C., Hu M., Liu X., Du J.

“…Different product and structure can be obtained by changing temperature. According to thermodynamic calculation, the principal electroreduction products are Ti and TiFe2 and then Ti and TiFe2 are formed by interdiffusion which is governed by temperature.…”
Get full text

Use of Enzymatic Bio-Fenton as a New Approach in Decolorization of Malachite Green by Afzal Karimi, Mostafa Aghbolaghy, Alireza Khataee, Shabnam Shoa Bargh

“…Decolorization rate showed different behaviors versus temperature changes. Initial rate of decolorization process was increased by increasing of temperature; after 30 minutes, especially at temperatures above 30°C, the decolorization rate was gradually reduced. …”
Get full text

Microstructure development during thermomechanical treatment of Al-Mg-Si alloy by Martinova Z., Zlateva G.

“…It was established that pre-aging at room temperature affected the morphology of dislocation structure induced by next cold deformation. …”
Get full text

The Study of Thermal Conditions on Weibel Instability by M. Mahdavi, H. Khanzadeh

“…Weibel electromagnetic instability has been studied analytically in relativistic plasma with high parallel temperature, where |α=(mc2/T∥)(1+p^⊥2/m2c2)1/2|≪1 and while the collision effects of electron-ion scattering have also been considered. …”
Get full text

Investigating Surface Effects on Thermomechanical Behavior of Embedded Circular Curved Nanosize Beams by Farzad Ebrahimi, Mohsen Daman

“…The effects of various parameters such as nonlocal parameter, surface properties, Winkler and Pasternak elastic foundations, temperature, and opening angle of circular curved nanobeam on the natural frequency and critical buckling load are successfully studied. …”
Get full text

Crack initiation and propagation on the polymeric material ABS (Acrylonitrile Butadiene Styrene), under ultrasonic fatigue testing by G. M. Domínguez Almaraz, E. Correa Gómez, J.C. Verduzco Juárez, J.L. Avila Ambriz

“…Three controlled actions were implemented in order to carry out fatigue tests at very high frequency on this material of low thermal conductivity, they are: a) The applying load was low to limit heat dissipation at the specimen neck section, b) The dimensions of testing specimen were small (but fitting the resonance condition), in order to restraint the temperature gradient at the specimen narrow section, c) Temperature at the specimen neck section was restrained by immersion in water or oil during ultrasonic fatigue testing. …”
Get full text

MICRO THERMAL ELASTOHYDRODYNAMIC LUBRICATION ANALYSIS OF LINE CONTACT ROLLER PAIRS CONSIDERING THE CHANGE OF ELASTIC MODULUS by LU ZunYou, LV YanJun

“…As an important performance parameter of metal materials,the elastic modulus changes with temperature.However,in the analysis of thermal elastohydrodynamic lubrication,the elastic modulus has been taken as a constant,and there must be an error in the calculation results. …”
Get full text

Study of Proton, Deuteron, and Triton at 54.4 GeV by M. Waqas, G. X. Peng

“…It is observed that the kinetic freeze-out temperature is increasing from the central to peripheral collisions. …”
Get full text

The influence of the rate of selenium crystallization from aqueous solutions on its morphology by Harañczyk I., Szafirska B., Fitzner K.

“…Selenium crystallization process from aqueous solutions was investigated at constant temperature of 357 K. Two different reducers were used, namely dissolved NaHSO3 and gaseous SO2. …”
Get full text

Massive Fluctuations in Deconfining SU(2) Yang-Mills Thermodynamics by Ingolf Bischer

“…However, an all-loop-order resummation of a class of 2PI bubble diagrams is shown to yield an analytic continuation of the low-temperature hierarchy to all temperatures in the deconfining phase.…”
Get full text

热采井口装置螺栓的蠕变及应力松弛规律研究 by 王亭沂, 曹旭祥, 李风, 孙爽

“…The stress relaxation phenomenon of bolt used in thermal recovery wellhead is studied experimentally under field conditions.The normal and high temperature tensile test,creep test and stress relaxation test are carried out respectively.The comparison of the experimental results shows that the strength of bolt material decreases and the plasticity increases at high temperature.The creep deformation is obvious under initial stress which explain the reason of stress relaxation in principle.The stress relaxation test,it can be found that the bolt stress have decreased obviously under the field condition.According to the stress relaxation experimental data,the stress relaxation formula under the field condition can be fitted.Finite element software is used to calculate the minimum pre-tightening load of bolts for each flange of KR21-370 thermal recovery wellhead device to achieve sealing.Combined with stress relaxation formula,the time required for flanges to fail due to stress relaxation of bolts is calculated.Solutions are proposed for bolts prone to failure.…”
Get full text

Study on Heat Dissipation of Reduction Gearbox of a Hoisting Mechanism in Stopped State by Gao Chunhui, Hu Xiong

“…In order to verify the actual influence of these factors on the reducer heat dissipation,by using the control variable method,the actual temperature data is computed and analyzed. Then,by means of the function mapping software Origin,the temperature data of the reduction gearbox is fitted,a quadratic exponential function model is fitted and the function parameter is obtained. …”
Get full text

Elimination of Odours from the Gaseous Phase on Cr- and Fe-modified Y-type Zeolites by Zenon Sarbak

“…Thus, 200 mg portions of the adsorbent were activated by heating at 400°C for 2 h after which the temperature was decreased to 200°C. The column was held at this temperature for 1 h and then 10 μl portions of n-butylamine and n-butylthiol were injected on to it at 15-min intervals. …”
Get full text

Comparative Analysis on Applicability of Satellite and Meteorological Data for Prediction of Malaria in Endemic Area in Bangladesh by Atiqur Rahman, Leonid Roytman, Mitch Goldberg, Felix Kogan

“…Correlation analysis of percent of malaria cases with Advanced Very High Resolution Radiometer- (AVHRR-) based VH indices represented by the vegetation condition index (VCI—moisture condition) and the temperature condition index (TCI—estimates thermal condition) and with rainfall, relative humidity, and temperature from ground-based meteorological stations. …”
Get full text