-
561
A Review on Synthesis, Properties, and Environmental Application of Fe-Based Perovskite
Published 2022-01-01“…Fe-based Perovskite exhibits a range of characteristics that become helpful for different applications such as catalysis, electrochemical sensors, and solar cells. This review summarizes the synthesis, properties, and environmental applications of Fe-based Perovskite. …”
Get full text
Article -
562
Recent Developments in Maximum Power Point Tracking Technologies for Photovoltaic Systems
Published 2010-01-01“…In photovoltaic (PV) system applications, it is very important to design a system for operating of the solar cells (SCs) under best conditions and highest efficiency. …”
Get full text
Article -
563
Visible Discrimination of Broadband Infrared Light by Dye-Enhanced Upconversion in Lanthanide-Doped Nanocrystals
Published 2014-01-01“…Optical upconversion of near infrared light to visible light is an attractive way to capture the optical energy or optical information contained in low-energy photons that is otherwise lost to the human eye or to certain photodetectors and solar cells. Until the recent application of broadband absorbing optical antennas, upconversion efficiency in lanthanide-doped nanocrystals was limited by the weak, narrow atomic absorption of a handful of sensitizer elements. …”
Get full text
Article -
564
New Hybrid Materials Synthesized with Different Dyes by Sol-Gel Method
Published 2017-01-01“…Such characteristics indicate the possible application of these films in solar cells.…”
Get full text
Article -
565
A Proposal for Long-Term Missions of Small Lunar Rovers Using an MLI Curtain System
Published 2019-01-01“…In order to enhance the feasibility of the MLI curtain system, we also propose ideas of a double-layer MLI and a rover configuration without solar cells.…”
Get full text
Article -
566
Alumina and Hafnia ALD Layers for a Niobium-Doped Titanium Oxide Photoanode
Published 2012-01-01“…Niobium-doped titanium dioxide (TiO2) nanoparticles were used as a photoanode in dye-sensitized solar cells (DSCs). They showed a high photocurrent density due to their higher conductivity; however, a low open-circuit voltage was exhibited due to the back-reaction of photogenerated electrons. …”
Get full text
Article -
567
Enhanced Performance of DSSCs Based on the Insertion Energy Level of CdS Quantum Dots
Published 2014-01-01“…To avoid the photo corrosion and electrolyte corrosion, CdS and N719 are sequentially assembled onto the nanocrystalline TiO2 films to prepare a CdS/N719 cosensitized photo electrode for the dye-sensitized solar cells. In the structure of TiO2/CdS/N719 electrode, the reorganization of energy levels between CdS and N719 forms a stepwise structure of band-edge levels which is advantageous to the electron injection and hole recovery of CdS and N719 QDs. …”
Get full text
Article -
568
Preparation and Properties of SnO2 Film Deposited by Magnetron Sputtering
Published 2012-01-01“…The effects of oxygen partial pressure percentage on the SnO2 property have been investigated to obtain relatively high-resistivity SnO2 films which could be used as buffer layers to optimize the performance of CdTe/CdS solar cells. The oxygen partial pressure percentage varied in the range of 1%~10%. …”
Get full text
Article -
569
Laser Enhanced Hydrogen Passivation of Silicon Wafers
Published 2015-01-01“…The laser hydrogenation process is then applied to finished screen-printed solar cells fabricated on seeded-cast quasi monocrystalline silicon wafers. …”
Get full text
Article -
570
Characterizations of Chitosan-Based Polymer Electrolyte Photovoltaic Cells
Published 2010-01-01“…These membranes have been used in the fabrication of solid-state solar cells with configuration ITO/TiO2/polymer electrolyte membrane/ITO. …”
Get full text
Article -
571
Thermoelectric Generators Applied as a Power Source in CubeSats: State of the Art
Published 2025-01-01“…While CubeSats currently rely on solar cells with efficiencies between 16.8% and 32.2%, their performance diminishes with increased distance from the Sun. …”
Get full text
Article -
572
Optical Properties of Thick TiO<sub>2</sub>-P25 Films
Published 2025-01-01“…Understanding these depth-dependent variations is essential for optimizing the use of TiO<sub>2</sub>-P25 films in technologies such as solar cells and optical devices.…”
Get full text
Article -
573
Maximum Power Point Tracking Based on Sliding Mode Control
Published 2015-01-01“…This generated power starts with the solar cells, which have a complex relationship between solar irradiation, temperature, and output power. …”
Get full text
Article -
574
A Low-Cost Photodiode Sun Sensor for CubeSat and Planetary Microrover
Published 2013-01-01“…Another estimation of the solar angle uses current measurements from orthogonal arrays of solar cells. The two methodologies are tested and compared on ground hardware. …”
Get full text
Article -
575
Unique Optoelectronic Properties and Applications of Lead‐Free Perovskites and Derivatives
Published 2025-02-01“…This shift is particularly vital in emerging technologies where perovskites play a crucial role, such as solar cells, X‐ray detectors, photodetectors, light‐emitting diodes (LEDs), etc. …”
Get full text
Article -
576
Effects of Controlling the AZO Thin Film's Optical Band Gap on AZO/MEH-PPV Devices with Buffer Layer
Published 2012-01-01“…Organic/inorganic hybrid solar cells were fabricated incorporating aluminum-doped zinc oxide (AZO) thin films of varying optical band gap in AZO/poly(2-methoxy-5-(2′-ethyl-hexyloxy)-p-phenylene vinylene) structures. …”
Get full text
Article -
577
Characteristics of DSSC Panels with Silicone Encapsulant
Published 2015-01-01“…Dye-sensitized solar cells (DSSC) allow light transmission and the application of various colors that make them especially suitable for building-integrated PV (BIPV) application. …”
Get full text
Article -
578
Machine learning‐assisted performance analysis of organic photovoltaics
Published 2024-12-01“…Abstract Although the power conversion efficiency of organic solar cells (OSCs) has been rapidly improved, there is still a lot of room for designing and developing new materials and their combinations to approach the efficiency limit. …”
Get full text
Article -
579
The Synthesis of 2D CH3NH3PbI3 Perovskite Films with Tunable Bandgaps by Solution Deposition Route
Published 2019-01-01“…Nowadays, organo-lead halide is one of the most interesting materials for perovskite solar cells. This is because of its ease of fabrication, long absorption wavelength region, and long diffusion length. …”
Get full text
Article -
580
Influence of Alkaline Treatment with Ammonia Water on the Properties of PEDOT: PSS Films
Published 2012-01-01“…We have also examined the performance of organic solar cells (OSCs) with the undoped and AW-doped PEDOT:PSS layers. …”
Get full text
Article