-
721
Simultaneous Measurements of PM2.5- and PM10-bound Benzo(a)pyrene in a Coastal Urban Atmosphere in Poland: Seasonality of Dry Deposition Fluxes and influence of Atmospheric Transpo...
Published 2021-07-01“…During the period from October to November, high Pb/Zn ratios in PM2.5 and PM10 were also observed, suggesting significant contribution of industrial emission (coal combustion) and local non-exhaust traffic emissions, including tyre abrasion in the case of Zn and the resuspension of road dust rich in Pb. …”
Get full text
Article -
722
Experimental Investigation of Brazilian 14-X B Hypersonic Scramjet Aerospace Vehicle
Published 2017-01-01“…The Brazilian hypersonic scramjet aerospace vehicle 14-X B is a technological demonstrator of a hypersonic airbreathing propulsion system based on the supersonic combustion (scramjet) to be tested in flight into the Earth’s atmosphere at an altitude of 30 km and Mach number 7. …”
Get full text
Article -
723
Research progress of Ti2AlNb alloy and feasibility analysis of its application in aero engines
Published 2025-01-01“…The analysis results indicate the feasibility of using Ti2AlNb alloy in aviation engines, with significant advantages in weight reduction: the alloy achieves a good balance of strength, toughness, and plasticity without obvious shortcomings; it has acceptable cold and hot processing performance, and can obtain engineering-sized parts through deformation, casting, and other methods; its combustion resistance is superior to traditional titanium alloys; when applied to static components such as casings, it can achieve a weight reduction of 35.3% compared to high-temperature alloys, and when applied to integral blade/disks and rotor components, it can achieve a weight reduction of 37.3% compared to nickel-based high-temperature alloys.…”
Get full text
Article -
724
Effect of vehicle operating parameters on fuel consumption and the overall energy efficiency of the drive system
Published 2024-12-01“…The application of the presented method enabled a comparison of the overall energy efficiency of two vehicles equipped with spark-ignition combustion engines, according to the criteria listed. …”
Get full text
Article -
725
The Role of Sulfur Emission from the Petroleum Industry on Ultrafine Particle Number Concentration in Singapore
Published 2022-12-01“…The particle number concentration (dp > 50 nm) correlated with the enhancements in CO concentration (ΔCO) for CH4-dominant air masses, suggesting that incomplete combustion processes, such as traffic emission, are important for the size range. …”
Get full text
Article -
726
Renewable Energy in Sudan: Current Status and Future Prospects
Published 2025-01-01“…ABSTRACT Sudan relies heavily on refined petroleum products for electricity generation, excluding hydropower, contributing to environmental degradation through petroleum combustion. This challenge underscores the need to expand renewable energy utilization. …”
Get full text
Article -
727
Study on Seismic Dynamic Response of Deep-Buried Tunnel Based on Tectonic Stress
Published 2022-01-01Get full text
Article -
728
Overview of Aerosol and Air Pollution in South Eastern Asia Countries
Published 2023-08-01“…The main potential sources of PM2.5 were diesel vehicle emission, a mixture of Cu industry and biomass combustion, metal industries using Ni, and construction, with contributions of 33%, 24.1%, 11.4%, and 7.9%, respectively. …”
Get full text
Article -
729
Annual Variation of PM2.5 Chemical Composition in Ho Chi Minh City, Vietnam Including the COVID-19 Outbreak Period
Published 2023-03-01“…The OC/EC ratio (3.28 ± 0.61) and char-EC/soot-EC (4.88 ± 2.72) suggested that biomass burning, coal combustion, vehicle emissions, cooking activities are major PM2.5 sources in HCMC. …”
Get full text
Article -
730
Decarbonization of space heating in the Italian Alpine context: Thermo-economic assessment of the levelized energy cost of heating under alternative renewable scenarios
Published 2025-01-01“…However, scenario (1) exhibits the highest competitiveness under recent subsidization policies, with a weighted average levelized energy cost of heat of 104 €/MWh, in line with the cost of standalone natural gas combustion in condensing boilers. PV delivers the second most cost-effective solution with strong improvement potential under grid electricity cost reductions. …”
Get full text
Article -
731
Aircraft hybrid-electric environment for analysis and design (AHEAD) applied on a fixed-wing drone
Published 2025-03-01“…Two topologies were analyzed: series configuration with internal combustion engine (ICE); and turbo-electric with fuel cell (FC). …”
Get full text
Article -
732
Modelling and analysis of coalbed methane drainage quality in penetrating-strata boreholes considering air leakage
Published 2025-12-01“…Air leakage should be prevented during CBM drainage because it can reduce drainage concentration and induce produce accidents such as coal seam spontaneous combustion. However, existing theoretical models for CBM drainage do not consider the air leakage effect. …”
Get full text
Article -
733
Heavy Metals Pollution and Pb Isotopic Signatures in Surface Sediments Collected from Bohai Bay, North China
Published 2014-01-01“…Compared with Pb isotopic radios in other sources, Pb contaminations in the surface sediments of Bohai Bay may be controlled by the mix process of coal combustion, aerosol particles deposition, and natural sources.…”
Get full text
Article -
734
Study on Pore and Fissure Structure Characteristics of Deep Soft Coal Rock
Published 2021-01-01“…The microscopic pore and fissure structure is the key factor affecting the exploitation, storage, and migration of coalbed methane and coal spontaneous combustion tendency. For further research of the microstructure of deep soft coal rock, such as pores and fissures, the coal samples from the Yangdong mining area were qualitatively and quantitatively analyzed in terms of morphological characteristics, pore shape, pore specific surface area, pore volume, and pore diameter by a scanning electron microscope (SEM) and a low-temperature liquid nitrogen adsorption experiment. …”
Get full text
Article -
735
A highly active, low-cost CoZn ferrite electrocatalyst in oxygen reduction reactions
Published 2025-03-01“…Fuel cell technology offers a promising alternative to fossil fuel combustion, providing a clean, eco-friendly and a more efficient energy source. …”
Get full text
Article -
736
Sub-seasonal Patterns of PM10 and Black Carbon in a Coastal City: A Case Study of Salé, Morocco
Published 2024-07-01“…The study centered on the repercussions of fossil fuel combustion (BCFF specifically, emissions from traffic) and biomass burning (BCBB Consisting of forest fires and agricultural burning) on BC2.5 levels. …”
Get full text
Article -
737
Ambient air pollution and carcinogenic activity at three different urban locations
Published 2025-01-01“…The obtained results indicated petrogenic and pyrogenic sources, petroleum combustion, and vehicle emission as dominant sources at the UR and UB locations, while vehicle emission, biomass and coal burning, and pyrogenic sources were recognized as dominant sources at the UI location. …”
Get full text
Article -
738
Soil Degradation Evidence Following a Wildfire in Arequipa’s Andean Region, Peru
Published 2025-01-01“…Soils under Berberis exhibited greater SOC losses, likely due to its larger biomass that intensified the combustion effects. The decrease in SOC resulted in soil compaction. …”
Get full text
Article -
739
Characteristics of Stratum Structure and Fracture Evolution in Stratified Mining of Shallow Buried High-Gas-Thick Coal Seam by Similarity Simulation
Published 2021-01-01“…The main coal seam thickness of Rujigou Coal Mine exceeds 20 m, due to the high gas content of the coal seam, it is prone to spontaneous combustion, and the stratified mining method is adopted. …”
Get full text
Article -
740
Characterizing PM2.5 Secondary Aerosols via a Fusion Strategy of Two-stage Positive Matrix Factorization and Robust Regression
Published 2023-10-01“…The results from the fusion model showed that the majority of secondary aerosols (sum of secondary aerosol-related species = 2.67 µg m−3) within three hours were mainly contributed by oil combustion, while the largest contributor of secondary aerosols (1.65 µg m−3) over 24 hours was industry, highlighting the need for regulation of these two sources based on various temporal scales. …”
Get full text
Article