-
1981
The Nonlinear Stability Prediction and FEM Modeling of High-Speed Spindle System with Joints Dynamic Characteristics
Published 2014-01-01“…In this paper, the distribution spring model of spindle-holder-tool joints was built with the consideration of its dynamic characteristics; the five-DOF dynamic model of the angle contact ball bearing was also established to study the influence of speed and preload on the spindle-bearing joint, both of which were used in the general whole complete spindle system FEM model. …”
Get full text
Article -
1982
Triaxial Test and Mechanical Analysis of Rock-Soil Aggregate Sampled from Natural Sliding Mass
Published 2015-01-01“…Further, the influences of stone content, and gradation variation on stress-strain curve, Mohr-Coulomb criterion based shear strength parameters, Duncan-Chang model based deformation parameters, and internal friction angle are analyzed. A modified Rowe’s stress-dilatancy equation describing the mechanical response of rock-soil aggregate is then suggested.…”
Get full text
Article -
1983
Progressive Corrosion Study of Metals like Mild Steel, Zinc and Aluminium in an Urban Atmosphere
Published 2009-01-01“…Mild steel panels exposed vertically suffer less corrosion than those exposed at an angle of 45°. The resistivity towards the atmosphere was in the increasing order: mild steel < zinc < aluminium. …”
Get full text
Article -
1984
Synthesis of an adaptive cylindrical gear with arched teeth with two contact zones spaced along the length of the tooth
Published 2023-11-01“…The article investigates an adaptive gear with arched teeth with two contact zones, which provides selfalignment of the wheels, regardless of the angle of misalignment of the teeth in engagement. …”
Get full text
Article -
1985
Parkinsonian Rigidity Depends on the Velocity of Passive Joint Movement
Published 2015-01-01“…The elbow joints of 20 Parkinson’s disease patients were passively flexed and extended, and two characteristic values, the elastic coefficient (elasticity) and the difference in bias (difference in torque measurements for extension and flexion), were identified from a plot of the angle and torque characteristics. Flexion and extension were done at two different velocities, 60°/s and 120°/s, and a statistical analysis was performed to determine whether the changes in these characteristic values were velocity-dependent. …”
Get full text
Article -
1986
Validation of a Novel Landmark-guided Intra-articular Postero-medial Surgeon-administered Injection Technique
Published 2025-02-01“…An orthopedic surgeon performed a medial parapatellar arthrotomy and introduced an 18-gauge needle 1-2 cm proximal to the palpated adductor tubercle angled posteromedially. Needle position and dye spread were fluoroscopically documented. …”
Get full text
Article -
1987
The surface of non-linear rotation
Published 2023-11-01“…It is known that in Euclidean geometry and mechanics the transformation of rotation is linear, while distance and angle are its invariants. The authors proposed a geometric scheme of non-linear rotation, in which the axis of rotation is a smooth spatial curve and the object of rotation is a smooth line. …”
Get full text
Article -
1988
Management of Complex Root Canal Curvature of Bilateral Radix Entomolaris: Three-Dimensional Analysis with Cone Beam Computed Tomography
Published 2013-01-01“…CBCT is useful in endodontics as it aids in the identification of essential anatomic structures and determination of radius and angle of root canal curvature which is linked to fracture of the instrument. …”
Get full text
Article -
1989
Effects of Factors That Influence Out-of-Plane Lateral-Torsional Buckling on Freestanding Circular Arches
Published 2020-01-01“…The studied factors that attribute to the effects of lateral-torsional buckling include cross section type, included angle, slender ratio, imperfection, loading, and boundary conditions. …”
Get full text
Article -
1990
Accurate 2-D AOA Estimation and Ambiguity Resolution for a Single Source under Fixed Uniform Circular Arrays
Published 2017-01-01“…This paper presents an analytic algorithm for accurate two-dimensional (2-D) angle of arrival (AOA) estimation of a single source under fixed uniform circular arrays (UCAs). …”
Get full text
Article -
1991
Research on Carrying Capacity of T-Shaped Stiffened Concrete-Filled Steel Tubular Columns Subjected to Eccentrically Compressive Load
Published 2021-01-01“…A parametric analysis was carried out to calculate M-N correlation curves of cross section and column to investigate influence of concrete strength fck, steel yielding strength fy, steel tube thickness t, slenderness ratio λ, and loading angle θ. On the basis of parametric analysis, simplified resistance models of T-shaped CFST section and column were proposed and verified by the numerical analysis results. …”
Get full text
Article -
1992
Structural Evolution of Low-Molecular-Weight Poly(ethylene oxide)-block-polystyrene Diblock Copolymer Thin Film
Published 2013-01-01“…The structural evolution of low-molecular-weight poly(ethylene oxide)-block-polystyrene (PEO-b-PS) diblock copolymer thin film with various initial film thicknesses on silicon substrate under thermal annealing was investigated by atomic force microscopy, optical microscopy, and contact angle measurement. At film thickness below half of the interlamellar spacing of the diblock copolymer (6.2 nm), the entire silicon is covered by a polymer brush with PEO blocks anchored on the Si substrate due to the substrate-induced effect. …”
Get full text
Article -
1993
Exploring the impact of HAp on the surface morphology, mechanical, wettability, and biodegradation rate of PVA-collagen nanofiber bone scaffolds
Published 2025-01-01“…In addition, the water contact angle decreased with increasing HAp concentration (a faster degradation rate), which was consistent with higher suitability degradation.…”
Get full text
Article -
1994
Bank collapse-landslide failure mechanism of typical reverse rock bank slope in Three Gorges Reservoir area
Published 2025-01-01“…At present, most of the reverse rock slope toppling instability failure is interpreted as a progressive overall instability failure controlled by dip angle and structural plane. However, the phenomenon of leading edge collapse is common in some reservoir areas before the toppling deformation of reverse rock slope is intensified or destabilized. …”
Get full text
Article -
1995
Klasifikasi Citra Sampah Menggunakan Support Vector Machine dengan Ekstraksi Fitur Gray Level Co-Occurrence Matrix dan Color Moments
Published 2022-10-01“…Some of the important parameters that are tuned in this study are the angle orientation of the GLCM, C (soft margin) parameter on the SVM, and ???? …”
Get full text
Article -
1996
Hydro-mechanical behavior of two clayey soils in presence of household waste leachates
Published 2022-04-01“…For soils from Nouna, the effective cohesion increases from 3 to 21 kPa with a slight decrease of friction angle; for soils from Boudry a slight increase of cohesion is noticed while friction angle increases from 34 to 37°.CONCLUSIONThis comparative study is of practical use to environmental geotechnics professionals because it shows that the choice in designing a bottom liner must be a compromise between long term hydraulic and mechanical behaviors of soils. …”
Get full text
Article -
1997
Geometrical determinants of cerebral artery fenestration for cerebral infarction
Published 2025-01-01“…Results The initiation angle φ1 and confluence angle φ2 at the fenestration in the Infarction Group are both smaller compared to the Control Group, but only the Infarction Group and BA Infarction Group have significant difference (p < 0.05). …”
Get full text
Article -
1998
A Local Adversarial Attack with a Maximum Aggregated Region Sparseness Strategy for 3D Objects
Published 2025-01-01“…Additionally, neural rendering is used to obtain gradient-propagating multi-angle augmented data and suppress the model’s detection to locate universal critical decision regions from multiple angles. …”
Get full text
Article -
1999
Autosomal Recessive Bestrophinopathy: Clinical and Genetic Characteristics of Twenty-Four Cases
Published 2021-01-01“…Eighteen patients (75%) had a thick choroid on EDI-OCT, of which three had advanced angle-closure glaucoma, 15 patients were hyperopic, and eight of them had more than four diopters hyperopia in both eyes. …”
Get full text
Article -
2000
Modeling and Oil Contamination Influence Control of a Vehicle Mounted and Unbalanced Barrel Pitching System
Published 2019-01-01“…The results show when the given angle is fixed on 25°, the setting time is reduced to 0.2 s, and the maximum steady state error is only 0.000132 rad. …”
Get full text
Article