-
1301
Human and Bovine Dentin Composition and Its Hybridization Mechanism Assessed by FT-Raman Spectroscopy
Published 2013-01-01“…The resulted forty dentin segments were treated either with the total-etch one bottle adhesive (Prime & Bond 2.1, PB) or with the single-step self-etching adhesive (Xeno III, X) and divided into four groups: HPB (control), HX, BPB, and BX. …”
Get full text
Article -
1302
The role of aging and various surface preparation methods in the repair of nanohybrid composites
Published 2025-01-01“…The aged and non-aged specimens were further divided into four groups according to adhesive application modes and surface pretreatment methods: 1.universal adhesive/self-etch mode, 2.aluminum oxide sandblasting + universal adhesive/self-etch mode, 3.universal adhesive/etch-and-rinse mode, 4.aluminum oxide sandblasting + universal adhesive/etch-and-rinse mode. …”
Get full text
Article -
1303
Do the Microshear Test Variables Affect the Bond Strength Values?
Published 2012-01-01“…In Group 3, composite rods without tubes were placed on adhesive covered dentin. In all groups, adhesives were photoactivated after positioning filled tubes/rods on adhesive covered surfaces. …”
Get full text
Article -
1304
Using a cohesive zone modeling to predict the compressive and tensile behavior on the failure load of single lap bonded joint
Published 2019-10-01“…The effect of these different parameters on the strength of the adhesive joint is presented as results by failure load curves…”
Get full text
Article -
1305
Effect of laser and light emitting diode bleaching techniques on micro-leakage of dental composite postoperatively using two different bonding systems
Published 2019-12-01“…After cavities were restored with two different adhesive systems and restored with composite resin, they were submitted to thermo-cycling procedures. …”
Get full text
Article -
1306
Study of the Antagonism of Biocontrol Strains Against the Blue-Stain Fungus of Rubberwood
Published 2025-01-01Get full text
Article -
1307
Effect of combining different 10-MDP-containing primers and cement systems on shear bond strength between resin cement and zirconia
Published 2025-02-01“…Conclusions Combining primers from different adhesive cement systems may significantly enhance the bond strength. …”
Get full text
Article -
1308
FBG-Based UV-Curing Kinetics Analysis by Exothermic Behavior
Published 2025-01-01“…The exothermic behavior of the UV curing adhesive during curing and the feasibility of FBG-based curing kinetic analysis scheme are verified experimentally, full cycle cure monitoring of the UV curing adhesive can be realized by this FBG-based curing kinetic analysis scheme, and the UV-curing kinetics of four different types of the UV curing adhesive are corresponding to different exothermic behaviors. …”
Get full text
Article -
1309
Durability of Wearable Antennas Based on Nonwoven Conductive Fabrics: Experimental Study on Resistance to Washing and Ironing
Published 2018-01-01“…Adhesive nonwoven conductive fabrics are appealing materials for fabricating fully textile antennas for wearable wireless systems. …”
Get full text
Article -
1310
Resin-Dentin Bonding Interface: Mechanisms of Degradation and Strategies for Stabilization of the Hybrid Layer
Published 2019-01-01“…A longer durability of adhesive restorations could resolve a variety of clinical problems, such as microleakage, recurrent caries, postoperative sensitivity, and restoration integrity.…”
Get full text
Article -
1311
Cold Lining and Mist Lining: insights and possibilities of adaptation to the mediterranean climate
Published 2013-05-01“…Bibliographic research on Mist Lining adhesives and comparative peeling tests were carried out at the University of Urbino were followed by a conservation treatment, confirming the possibility of adapting the Mist Lining technique to the needs of the Mediterranean climate, substituting the solvents and adhesives used by J.V.Och without any loss of efficiency.…”
Get full text
Article -
1312
Treatment of a Vertical Root Fracture Using Dual-Curing Resin Cement: A Case Report
Published 2012-01-01“…However, bonding of the fracture line with adhesive resin cement during the intentional replantation procedure was recently suggested as an alternative to tooth extraction. …”
Get full text
Article -
1313
An Unusual Extremely Distant Noncommunicating Uterine Horn with Myoma and Adenomyosis Treated with Laparoscopic Hemihysterectomy
Published 2013-01-01“…Moreover, omentum and bowel were attached to fundus of right horn and thick adhesions fixed it to rectum and right pelvic wall. …”
Get full text
Article -
1314
Use of combined CZM and XFEM techniques for the patch shape performance analysis on the behavior of a 2024-T3 aluminum structure reinforced with a composite patch
Published 2022-09-01“…The composite patch is of the carbon/epoxy type bonded through an A-140 Adekit type adhesive on the damaged part of the plate. The analysis consists in determining the force-displacement curves of the repaired structure by using the combination of the two techniques, XFEM for the damage of the aluminum plate 2024-T3 by the automatic creation of the crack and CZM for the analysis of the adhesive debonding. …”
Get full text
Article -
1315
Fatigue Behaviour of Mechanical Joints: A Review
Published 2024-12-01“…For instance, the fatigue behaviour of adhesive joints is affected by the bond length, thickness and the use of different materials. …”
Get full text
Article -
1316
Antepartum Risk Factors for Peripartum Hysterectomy in Women with Placenta Previa
Published 2014-04-01“…Antepartum evaluation of adhesive disorders with imaging studies may play a crucial role in predicting hysterectomy in these cases. …”
Get full text
Article -
1317
Impact of Application of Multifunction Electrode (MFE) Pads on Cardiopulmonary Resuscitation Quality
Published 2020-01-01“…All teams in scenario with adhesive electrodes were able to administer two doses of adrenaline, meanwhile only 74% of them in group C (p<0.001). …”
Get full text
Article -
1318
Characterization of Polymer Surfaces by the Use of Different Wetting Theories Regarding Acid-Base Properties
Published 2017-01-01“…Striving for a better understanding of the adhesive polymer interactions in adhesively joined polymers, the methods of Berger and van Oss-Chaudhury-Good were found as the most suitable methods for the investigation of wetting on solid polymer surfaces. …”
Get full text
Article -
1319
Rash with DERMABOND PRINEO Skin Closure System Use in Bilateral Reduction Mammoplasty: A Case Series
Published 2015-01-01“…The recently introduced DERMABOND PRINEO Skin Closure System Skin Closure System combines the skin adhesive 2-octyl cyanoacrylate with a self-adhering polyester-based mesh. …”
Get full text
Article -
1320
Characterization of Modified Tapioca Starch Solutions and Their Sprays for High Temperature Coating Applications
Published 2014-01-01“…The objective of the research was to understand and improve the unusual physical and atomization properties of the complexes/adhesives derived from the tapioca starch by addition of borate and urea. …”
Get full text
Article