-
41
Exploring the characteristics of detrusor after contraction in females with pure urodynamic stress incontinence
Published 2025-01-01Subjects: Get full text
Article -
42
A De Novo Frameshift Variant in SMC1A Causes Non‐Classic Cornelia de Lange Syndrome With Epilepsy: A Case Report and Literature Review
Published 2025-01-01Subjects: Get full text
Article -
43
Costoclavicular block as a diaphragm-sparing nerve block for shoulder surgery: a randomized controlled trial
Published 2025-02-01Subjects: Get full text
Article -
44
Integrated Planning for Shared Electric Vehicle System Considering Carbon Emission Reduction
Published 2024-12-01Subjects: Get full text
Article -
45
-
46
Simulating the Effects of Structural Parameters on the Hydraulic Performances of Venturi Tube
Published 2012-01-01“…With an inlet diameter of 50 mm, based on the method of computational fluid dynamics (CFD), the effects of the structural parameters (such as throat taper, throat contraction ratio, and throat length) on their hydraulic performance (such as outlet faceted average velocity, minimum pressure, and critical pressure) were studied under different inlet pressures and pressure differences between inlet and outlet. …”
Get full text
Article -
47
Numerical Study on the Optimization Design of Photovoltaic/Thermal (PV/T) Collector with Internal Corrugated Channels
Published 2022-01-01“…The results indicate that increasing inlet water velocity leads to a decrease in the outlet temperature. It was found that the corrugation area and the flow channel width have impacts on the outlet temperature of the hybrid PV/T collector panel. …”
Get full text
Article -
48
Effect of Fluid Flow Rate on Efficacy of Fluid Warmer: An In Vitro Experimental Study
Published 2018-01-01“…Effective warming was defined as an outlet fluid temperature of >32°C. Results. The room temperature was 23.6°C ± 0.9°C. …”
Get full text
Article -
49
HEAT DISSIPATION ON THE LATERAL SURFACE OF CYCLONE CHAMBER WITH ASYMMETRICAL TWO-WAY GAS INPUT AND OUTPUT
Published 2014-08-01“…The relative values of input gas flow and the relative diameters of the outlet are different in each of the halves of the working volume. …”
Get full text
Article -
50
Analysis and optimization of LN2 two-phase flow in CRAFT NNBI cryopump
Published 2025-02-01“…The simulation results show that the optimized structure B can reduce the pressure drop by 3 bar, the outlet temperature of structure A is 78.8 K, the outlet temperature of structure B is 79.2 K, the temperature difference is 0.4 K. …”
Get full text
Article -
51
Thermosetting Coupling Analysis and Parameter Optimization of the Plastic Lining Pump Structure
Published 2019-01-01“…In order to obtain the optimum structure of the lining pump under the condition of fluid thermosetting coupling, according to the given design parameters, the structural parameters of the pump were calculated, the three-dimensional geometric model was established, and the flow field analysis was carried out by CFD; the inlet angle βb1, outlet angle βb2, wrap angle φ, inlet diameter D1, and outlet diameter D2 of the impeller were selected as the five factors to design orthogonal experiment, and the results were analyzed by range analysis; then, the efficiency and cavitation allowance were obtained as combined parameters under the evaluation index. …”
Get full text
Article -
52
Analisis Loyalitas Pelanggan Berbasis Model Recency, Frequency, dan Monetary (RFM) dan Decision Tree pada PT. Solo
Published 2020-10-01“…Model klasterisasi RFM dan klasifikasi Decision Tree telah menghasilkan atribut outlet yang berpengaruh terhadap nilai akurasi sebesar 67,54%. …”
Get full text
Article -
53
The Airflow Reversal Law in Ventilation System after Coal and Gas Outburst in Tunneling Roadway
Published 2021-01-01“…Furthermore, the air velocity decreases from −1.38 to −284.44 m/s in the inlet and increases from 3.10 to 297.38 m/s in the outlet. Moreover, the gas concentration of the inlet and outlet in return airway increases rapidly with the increase of outburst pressure. …”
Get full text
Article -
54
Minimizing Thermal Stress for Data Center Servers through Thermal-Aware Relocation
Published 2014-01-01“…The contribution of this paper is bringing the peak outlet temperatures of the relocated servers closer to average outlet temperature by over 5 times, lowering the average peak outlet temperature by 3.5% and minimizing the thermal stress.…”
Get full text
Article -
55
Nonobstructive gastroduodenal intussusception characterized by severe anemia: a case report
Published 2025-02-01“…Its clinical presentation often includes nonspecific signs of gastric outlet obstruction, such as nausea, vomiting, abdominal pain, epigastric fullness, or abdominal distention. …”
Get full text
Article -
56
Measurements of Basic Performances for Waterjet Propulsion Systems in Water Tunnel
Published 1995-01-01“…The optimization study of the water jet systems is conducted by simulating the change of the nozzle outlet diameter with the variable nozzle arrangement. …”
Get full text
Article -
57
Optimization and experimental validation of a high-efficiency oil–water cyclone separator for well testing conditions
Published 2025-01-01“…The optimal parameter combination was determined: oil outlet diameter of 4.241 mm and cyclone chamber cone angle of 9.622°. …”
Get full text
Article -
58
Analyses of the Design of Multirows Vaneless Staggered Counter-Rotating Turbine
Published 2022-01-01“…The coordination of inlet swirl and outlet Mach number and the outlet angle is discussed by the theoretical method. …”
Get full text
Article -
59
Effects of Inlet Pressure on Ignition of Spray Combustion
Published 2018-01-01“…To evaluate the effects of inlet pressure on the ignition process of spray combustion, the images of the ignition process were recorded and the outlet temperatures were measured under inlet pressure of 0.04–0.16 MPa. …”
Get full text
Article -
60
Research on leakage and diffusion behavior of hydrogen doped natural gas in integrated pipeline corridors based on data drive
Published 2025-01-01“…At the same time, the greater the distance between inlet and outlet, the wider the spread of the dangerous area, when the distance between inlet and outlet is reduced from 200 m to 100 m, the explosion volume of CH4 is reduced by 99.92%, and the explosion volume of H2 is reduced by 100%. …”
Get full text
Article