-
681
Influence of Starkeya novella on Mechanical and Microstructural Properties of Cement Mortars
Published 2020-01-01“…Compressive strength was determined after the 7th, 28th, 56th, and 90th day of curing. Scanning electron microscopy (SEM) was tested on both bacterial and control mortar prisms after the 28th day of curing. …”
Get full text
Article -
682
Laboratory Investigation into Early-Age Strength Improvement of Cold Recycled Asphalt Mixture Containing Asphalt Emulsion and Cement
Published 2019-01-01“…Also, high cement content was helpful to increase the early-age strength. By changing the curing environment, it was found that raising curing temperature and applying a relatively low humidity contributed to the early-age strength improvement. …”
Get full text
Article -
683
UJI EFEKTIVITAS EKSBIMA SEBAGAI SUBTITUTOR SIDABAS 500 SC TERHADAP HAMA THRIPS (Thrips sp) PADA TANAMAN CABAI RAWIT (Capsicum frutescens L.)
Published 2015-04-01“…Research to determine the effectiveness of the extract against diseases curly terms of cure rates and yields of crops cayenne pepper (Capsicum frutescens l.) …”
Get full text
Article -
684
Causes of Early Age Cracking on Concrete Bridge Deck Expansion Joint Repair Sections
Published 2014-01-01“…These results underscore the significance of proper moist curing methods for concrete bridge decks, including repair sections. …”
Get full text
Article -
685
Experimental studies on mix design and properties of ceramic-glass geopolymer mortars using response surface methodology
Published 2025-01-01“…According to response surface methodology results, the maximum compressive strengths of 22.79 MPa at three days and 25 MPa at 28 days were achieved using a mix containing 85.8% CWP, a 1.02 sodium hydroxide (NH): sodium silicate (NS) ratio, a 0.647 S: B ratio, and a 12-h oven curing time. Optimal oven curing conditions resulted in 28-day compressive strength, flexural strength, and UPV values of 25.7 MPa, 5.62 MPa, and 5765 m/s, respectively. .…”
Get full text
Article -
686
The Study’s Chemical Interaction of the Sodium Silicate Solution with Extender Pigments to Investigate High Heat Resistance Silicate Coating
Published 2021-01-01“…Moreover, TG results of ZnO-silicate, TiO2-silicate, CaCO3-silicate, Na2SiF6-silicate, and Fe2O3-silicate coating at 1 and 20 days of curing show high residual geopolymer about 69–90% at 800°C. …”
Get full text
Article -
687
Unconfined Compressive Strength of Aqueous Polymer-Modified Saline Soil
Published 2019-01-01“…Based on the increase of the ZM admixture, the UCS increases with the curing time. The main increment of the UCS occurs within the first seven days of curing. …”
Get full text
Article -
688
Efficacy and Safety of Oral Itraconazole and Griseofulvin versus Itraconazole Alone in Patients with Tinea Corporis and Cruris Infection: A Comparative Clinical Study
Published 2024-12-01“…The marked cure was 4 (7.2%) in Group I, whereas 17 (31%) in Group II. …”
Get full text
Article -
689
Coupled Analysis of Thermofluid-Structure Field for Thermal Properties of Early-Age Concrete Influenced by Electric Heating System
Published 2022-01-01“…The key contribution of this research is to provide a coupling model for concrete curing. The findings from the study also provide industry practitioners with a comprehensive guide regarding the specific applications of the electric heating system in early-age concrete curing.…”
Get full text
Article -
690
A Comparative Study on the Thermal Conductivity of Concrete with Coal Bottom Ash under Different Drying Conditions
Published 2021-01-01“…The thermal conductivity of concrete was measured under two different curing and drying conditions: oven-dried conditions and saturated surface-dry (SSD) conditions, with curing times of 28 and 91 days. …”
Get full text
Article -
691
Modifiable lifestyle factors are associated with lower pain levels in adults with knee osteoarthritis
Published 2015-01-01“…BACKGROUND: With no cure or effective treatments for osteoarthritis (OA), the need to identify modifiable factors to decrease pain and increase physical function is well recognized.…”
Get full text
Article -
692
-
693
Utility of Serology in Determining Helicobacter pylori Eradication after Therapy
Published 1998-01-01“…OBJECTIVE: To determine the usefulness of four serological tests in confirming cure of H pylori infection before the previously reported six-month post-treatment delay.…”
Get full text
Article -
694
Postphlebitic ulcer treatment with platelet-rich plasma and autograft of skin. Case Presentation
Published 2017-06-01“…It was applied a treatment with autologous plasma gel rich in platelets and then autografting skin free, of medium thickness. After curing the grafted area and performing cures on an outpatient basis for three weeks, healing was achieved in more than 70% of the initially affected area. …”
Get full text
Article -
695
Improvement of Interfacial Shear Strength of Mendong Fiber (Fimbristylis globulosa) Reinforced Epoxy Composite Using the AC Electric Fields
Published 2015-01-01“…For this purpose, the epoxy (DGEBA) with a cycloaliphatic amine curing agent was treated by the AC electric field during the curing process. …”
Get full text
Article -
696
Development of 3D satisfaction surface for concrete durability design under chloride attack considering climate change
Published 2025-07-01“…Experimental results indicate that higher curing temperatures increase chloride penetration, whereas higher humidity improves resistance. …”
Get full text
Article -
697
Predictive Factors, Treatment, and Outcomes of Coagulase-Negative Staphylococcal Peritonitis in Malaysian Peritoneal Dialysis Patients: A Single-Center Study
Published 2022-01-01“…CoNS episodes that were treated with beta-lactam-based or vancomycin-based therapy had a similar primary response rate and complete cure rate. The rates of relapse and repeat were 12% and 16%, respectively. …”
Get full text
Article -
698
Chloride Ingress in Cement Mortars Exposed to Acidithiobacillus thiooxidans Bacteria
Published 2020-01-01“…The test prisms were subjected to porosity and accelerated chloride ingress after 28th day of curing. Compressive strength was determined after the 2nd, 7th, 28th, and 56th days of curing. …”
Get full text
Article -
699
Improving the Mechanical Properties of Red Clay Using Xanthan Gum Biopolymer
Published 2021-01-01“…The xanthan gum content and curing age also had significant influences on the cohesion but not on the internal friction angle. …”
Get full text
Article -
700
Imperatorin’s Effect on Myocardial Infarction Based on Network Pharmacology and Molecular Docking
Published 2025-01-01“…Thus, imperatorin might be considered a potential therapeutic agent to cure MI.…”
Get full text
Article