Effects of Water Immersion on the Adhesion between Adhesive Layer and Concrete Block by Jiajun Shi, Yunfeng Pan, Hedong Li, Jun Fu

“…The moisture content distribution and the hygrothermal stress were determined by using the finite element method (FEM). The mode I fracture energy was found decreasing with increasing immersion time. …”
Get full text

Seismic Response Mitigation of a Long-Span Tower Bridge with Two Types of Constraint System by Li Xu, Qingfei Gao, Junhao Zheng, Chuanhui Ding, Kang Liu

“…In this article, a nonlinear finite element model is established based on a large span concrete cable-stayed bridge with a main span of 680 m. …”
Get full text

Experimental and numerical studies on the vibration serviceability of fanshaped prestressed concrete floor by Liang Cao, Hongtuo Qi, Jiang Li

“…Running tests and simulation were also performed to capture the acceleration responses. Moreover, the finite element method was used to evaluate the dynamic characteristics. …”
Get full text

Mechanical Properties Measurement of Polymer Films by Bulge Test and Fringe Projection by C. S. Lin, T. L. Horng, J. H. Chen, K. H. Chen, J. J. Wu, C. Y. Chen, S. H. Ma

“…Also, the measurements were validated to be highly accurate by comparison with a finite element analysis.…”
Get full text

Random Vibration Analysis of Train Moving over Slab Track on Bridge under Track Irregularities and Earthquakes by Pseudoexcitation Method by Zhiping Zeng, Kunteng Zhu, Xianfeng He, Wentao Xu, Lingkun Chen, Ping Lou

“…The track and bridge is simulated by a rail-slab-girder-pier interaction finite element model. The coupling equations of motion are established based on the wheel-rail interaction relationship. …”
Get full text

Pounding Effects in Simply Supported Bridges Accounting for Spatial Variability of Ground Motion: A Case Study by G. Tecchio, M. Grendene, C. Modena

“…In order to include the effects due to the main nonlinear behaviours of the bridge components, a 3D finite element model has been developed, in which the pounding of decks at cap-beams, the friction of beams at bearings, and the hysteretic behaviour of piers have been accounted for. …”
Get full text

Performance analysis of dual stator six‐phase embedded‐pole permanent magnet synchronous motor for electric vehicle application by Raja Ram Kumar, Priyanka Devi, Chandan Chetri, Ankita Kumari, Papu Moni Saikia, Ram Khelawan Saket, Kundan Kumar, Baseem Khan

“…For performance evaluation, the Finite Element Method analysis is chosen, as it gives appropriate and precise results. …”
Get full text

Large Deformation Elastic Analysis of Pressurized FGM Thick Cylindrical Shells with Nonlinear Plane Elasticity Theory (NPET) by Navid Bahadorani, Mehdi Ghannad, Mohammad Hossein Sohani, Bahman Modiri

“…To investigate the accuracy of the results obtained from the analytical solution, the numerical finite element modeling of the mentioned cylinder with ABAQUS software based on the nonlinear elasticity theory is done and the results of the two methods are compared. …”
Get full text

Influence of Support Stiffness on Dynamic Characteristics of the Hydraulic Pipe Subjected to Basic Vibration by Wei Qu, Huailiang Zhang, Wei Li, Wenqian Sun, Lina Zhao, Haihui Ning

“…The bidirectional fluid-solid coupling analysis method was used to investigate dynamic characteristics of the pipeline under different support stiffness conditions. The finite element method (FEM) and the experimental analysis are applied to verify the proposed methodology. …”
Get full text

Research on extrusion welding of dissimilar magnesium alloys: Mg–Al–Zn and Mg–Gd by Jieyu Li, Shengwen Bai, Zhihua Dong, Yan Yang, Jiangfeng Song, Weijun He, Guangsheng Huang, Bin Jiang

“…Extrusion welding experiments were conducted using three combinations: AZ31 and Mg-1.5Gd (AG), AZ31 and AZ31 (AA), and Mg-1.5Gd and Mg-1.5Gd (GG), at different temperatures, accompanied by finite element (FE) simulations. The microstructures of the welding interfaces of the three types of sheets were examined, and the extrusion welding behavior of the AG sheets was analyzed by integrating the experimental and simulation results. …”
Get full text

Dislocation density-based simulation of pre-mixed jet effects on residual stress and cell size in 18CrNiMo7-6 alloy steel by MingHao Zhao, HaiYang Hou, FeiHu Ren, Chunsheng Lu, JianWei Zhang, BingBing Wang

“…In this paper, a finite element model is developed to investigate residual stress and microstructural changes in 18CrNiMo7-6 alloy steel during pre-mixed jet strengthening. …”
Get full text

Optimization of circular coils with ferrite boxes for enhanced efficiency in wireless power transfer for electric vehicles by Soukaina Jaafari, Hamza El Hafdaoui, Khadija Ajabboune, Ahmed Khallaayoun, Esmail Ahouzi

“…Utilizing ferrite cores to enhance performance, the study employs ANSYS Electronics Suite R2-202 and the finite element method to analyze circular coils, exploring variations in turns, inner radius, air gap, and misalignment's impact on the coupling coefficient. …”
Get full text

Numerical modeling of RC column reinforced by new strategy using fiberglass tape and cloth by Aissa Boumedjane, Saadi Mohamed, Yahiaoui Djarir, noureddine Lahbari

“… This paper presents the results of finite element analysis (FE) to study the axial compression behavior of reinforced concrete columns wrapped with tapes and fiberglass cloths according to different techniques using ABAQUS software. …”
Get full text

A Damage Detection Algorithm Utilizing Dynamic Displacement of Bridge under Moving Vehicle by Zhen Sun, Tomonori Nagayama, Di Su, Yozo Fujino

“…Beam model is established in commercial finite element software ABAQUS. The effects of road surface roughness and vehicle-bridge interaction are both considered in the analysis. …”
Get full text

Contact Load and Elastohydrodynamic Lubrication Analysis of Eccentric Bearings in RV Reducer Considering the Effects of Roller Profile Modification by Xinyue Zhang, Gang Wang, Daqi Wu, Jian Guan, Wenjie Chen

“…By combining the finite element model (FEM) and the elastohydrodynamic lubrication (EHL) method, a comprehensive model for the cylindrical roller bearings applied in the RV reducer is developed in this study. …”
Get full text

Acoustic interaction of submerged thin-shell structures considering seabed reflection effects by Xin Zhang, Kai Ai, Sen Yang, Sen Yang, Qingxiang Pei, Qingxiang Pei, Guang Lei, Guang Lei

“…The study employs the finite element method (FEM) with Kirchhoff-Love shell elements to numerically analyze thin-shell vibrations. …”
Get full text

Influence of Seismic Loading on Segment Opening of a Shield Tunnel by Yang Chun-shan, Mo Hai-hong, Chen Jun-sheng, Wang Yi-zhao

“…The influence of seismic loading on segment opening of a shield tunnel was explored using the dynamic finite element method to analyze the distribution of segment opening under multidirectional seismic loading, combined with a typical engineering installation. …”
Get full text

Flexible Temporary Shield in Soft and Sensitive Clay: 3D FE Modelling of Experimental Field Test by Miah Alam, Omar Chaallal, Bertrand Galy

“…A finite-element (FE) numerical study using PLAXIS-3D software was carried out to reproduce and validate a full-scale experimental in situ test and to investigate the earth pressure on a flexible temporary trench box shield in soft and sensitive clay soil. …”
Get full text

Crosswind and Vortex Usages for Electricity Production Enhancement of Solar Updraft Tower by Amnart Boonloi, Anan Sudsanguan, Withada Jedsadaratanachai

“…The research utilizes the finite element method, along with real model construction, to validate the reliability of the study’s findings. …”
Get full text

Influence of Foundation Pit Excavation and Precipitation on Settlement of Surrounding Buildings by Hongming Wei

“…The main research work includes the following aspects: summarizing and analyzing the soil consolidation theory, foundation pit excavation, and precipitation process; the influencing factors of the adjacent soil layer displacement; the influence mechanism and influence types of foundation pit excavation and precipitation on adjacent buildings. The finite element model considering the whole process of foundation pit excavation is established, and the variation law of the upper layer displacement around the foundation pit is analyzed. …”
Get full text