-
21
The Effect of Postoperative Tranexamic Acid and Dexamethasone on Quality of Recovery After Arthroscopic Rotator Cuff Repair: a Double-Blinded, Randomized Controlled Trial
Published 2025-01-01“…Patients were randomized to intravenously receive 200mL of normal saline (control group), 200mL of 1g TXA in saline (TXA group), or 200 mL of 1g TXA and 5mg DEX in saline (TXA+DEX group) within 2 hours postoperatively. …”
Get full text
Article -
22
习水国家级自然保护区野猪活动特征和危害分析
Published 2022-01-01“…危害集中发生在距离林区≤50 m、距居民区≥200 m、距道路≤100 m和距水源≤50 m的区域。研究结果可为习水国家级自然保护区野猪种群管理及非洲猪瘟管控提供基础性数据。…”
Get full text
Article -
23
Association between terminal pleural elastance and radiographic lung re-expansion after therapeutic thoracentesis in patients with symptomatic pleural effusion: a post-hoc analysis...
Published 2022-07-01“…We investigated the association between lung re-expansion on post-pleural drainage chest imaging and pleural physiology, with particular attention to pleural elastance over the final 200 mL aspirated.Design Post-hoc analysis of a recent randomised trial.Setting and participants Post-results analysis of 61 subjects at least 18 years old with symptomatic pleural effusions estimated to be at least of 0.5 L in volume allocated to manometry-guided therapeutic thoracentesis in a recent randomised trial conducted at two major university hospitals in the USA.Primary outcome measures The primary outcome was concordance of radiographic with normal terminal pleural elastance over the final 200 mL aspirated. …”
Get full text
Article -
24
Carbon injection potential of the mesopelagic-migrant pump in the Southern Ocean during summer
Published 2025-01-01“…In addition, carbon-rich particles are actively injected to depth through the diel vertical migration (DVM) of micronekton and mesozooplankton from the surface to the oceans’ twilight zone (200 m – 1000 m depth). This is known as the mesopelagic-migrant pump (MMP). …”
Get full text
Article -
25
Temporal and Spatial Characteristics and Influencing Factors of Carbon Storage in Black Soil Area Under Topographic Gradient
Published 2024-12-01“…Carbon storage was dominant at elevation I (range is 0–200 m), slope I (range is 0–2°), and relief amplitude I (range is 0–30 m). …”
Get full text
Article -
26
白鹳繁殖的初步观察
Published 1991-01-01“…地理坐标为北纬44°29′30″—45°19′30″,东经12°41′30″—122°14′30″,平均海拔高度在200m左右,总面积为1340km<sup>2</sup>。是以湿地草原珍禽为主要保护对象的综合性自…”
Get full text
Article -
27
Coral Reefs: Beyond Mortality?
Published 2000-01-01“…., but it is now possible to swim for over 200 m and see not one remaining living coral or soft coral on some previously rich reefs.…”
Get full text
Article -
28
Estimación de las constantes elásticas del terreno en el área de Salazar, Estado de México, a través de exploración sísmica
Published 2000-01-01“…Las velocidades fueron de 200 m/s y 107 m/s, respectivamente, para la primera interfase limo-arenosa, cuyo espesor estimado es de 3.46 m. …”
Get full text
Article -
29
Research and Design of Flood Discharge and Energy Dissipation Structures of Datengxia Hydro Project
Published 2022-01-01“…The design of flood discharge and energy dissipation structures is important and is the primary research problem in the layout of hydro projects,which involves the problems of discharge capacity,cavitation of flow surface,water aeration,and sediment abrasion and scouring of downstream riverbeds.For the Datengxia hydro project,its maximum discharge capacity of flood discharge structures reaches 66,200 m<sup>3</sup>/s,and the Froude number of energy dissipation structures is low.Therefore,the scheme of bottom outlets for flood discharge and surface outlets for drift discharge is adopted for flood discharge structures,and the underflow energy dissipation mode of the secondary stilling basin is adopted for energy dissipation structures.As flood discharge structures mainly adopt the bottom outlets for flood discharge,and the radial gate bears huge water thrust,the steel beam is selected as the radial gate support,which solves the difficulties in engineering design and provides a reference for similar projects.…”
Get full text
Article -
30
无动物源性成分人胚胎干细胞培养体系与其它人胚胎干细胞培养体系的比较
Published 2012-01-01“…【方法】 四种培养体系分别为:新建立的无动物源性的人包皮饲养层(XF-HFF)联合成分确定培养基(CDM)的无动物源性培养体系(XF-HFF/CDM),对照组为XF-HFF联合添加了200 mL/L人血清(HS)的培养基的培养体系(XF-HFF/HS),HS包被的培养皿联合CDM的无饲养层培养体系(HS-Matrix/CDM),以及传统的人包皮饲养层(XC-HFF)联合添加了200 mL/L血清替代物(KSR)的培养基的培养体系。…”
Get full text
Article -
31
Feasibility study of a randomised controlled trial of preoperative and postoperative nutritional supplementation in major lung surgery
Published 2022-06-01“…The intervention involved preoperative carbohydrate-loading drinks (4×200 mL evening before surgery and 2×200 mL the morning of surgery) and early postoperative nutritional protein supplement drinks two times per day for 14 days compared with the control group receiving an equivalent volume of water.Setting Single adult thoracic centre in the UK.Participants All adult patients admitted for major lung surgery. …”
Get full text
Article -
32
Transcriptomic and enzymatic analysis of peroxidase families at the early growth stage of halophyte ice plant (Mesembryanthemum crystallinum L.) under salt stress
Published 2025-01-01“…Ice plant seedlings display moderate salt tolerance, with root growth unaffected by 200 mM NaCl treatments, though hypocotyl elongation is hindered in salt-stressed etiolated seedlings. …”
Get full text
Article -
33
Experimental Study on the Aeolian Sand Solidification via MICP Technique
Published 2022-01-01“…The bender element results show that the wave speed of loose aeolian sand is 200 m/s; however, after solidification of the aeolian sand, the speed of P-wave is about 450-600 m/s and S-wave is about 350-500 m/s. …”
Get full text
Article -
34
Diamond-Like Carbon Film Deposition Using DC Ion Source with Cold Hollow Cathode
Published 2014-01-01“…Deposition was performed under various conditions. The pressure (12–200 mPa) and the plasma-forming gas composition consisting of different organic compounds and hydrogen (C3H8, CH4, Si(CH3)2Cl2, H2), the voltage of accelerating gap in the range 0.5–5 kV, and the substrate temperature in the range 20–850°C were varied. …”
Get full text
Article -
35
Performance of Asymmetric Electric Double Layer Capacitors — Predominant Contribution of the Negative Electrode
Published 2008-09-01“…Their rate performance, as evaluated from the ratio of the capacitance at 200 mA to that at 20 mA, C 200 /C 20 , was determined by the mesoporous surface area of the negative carbon electrode. …”
Get full text
Article -
36
Effectiveness of Variable Message Signs on Driving Behavior Based on a Driving Simulation Experiment
Published 2014-01-01“…Based on the research findings, it is suggested that VMS would be positioned between 150 m and 200 m upstream of the diverging point to balance the VMS effects on traffic safety and operation and the graphic information VMS format is better than the format with text massage only.…”
Get full text
Article -
37
青岛东方铁塔股份有限公司
Published 2015-01-01“…项目合同金额约为2,100万元,这是青岛东方铁塔承接的又一座总高度超过200m的全钢结构广播电视塔。…”
Get full text
Article -
38
Electrochemical Studies of Betti Base and Its Copper(II) Complex by Cyclic and Elimination Voltammetry
Published 2013-01-01“…The cyclic voltammetric studies carried out at a glassy carbon working electrode, Ag/Ag+ reference electrode (0.01 M AgNO3 in acetonitrile) in DCM at 100 mV/sec, 200 mV/sec, and 400 mV/sec scan rates indicated a preceding chemical oxidation of the adsorbed BB species to form an iminium ion followed by formation of a carbanion via two-step quasireversible reduction. …”
Get full text
Article -
39
Aviation Model: A Fine-Scale Numerical Weather Prediction System for Aviation Applications at the Hong Kong International Airport
Published 2013-01-01“…This new NWP model system, called Aviation Model (AVM), is configured at a horizontal grid spacing of 600 m and 200 m. It is based on the WRF-ARW (Advance Research WRF) model that can have sufficient computation efficiency in order to produce hourly updated forecasts up to 9 hours ahead on a future high performance computer system with theoretical peak performance of around 10 TFLOPS. …”
Get full text
Article -
40
Effects of personalized 3D-printed blocks in total knee arthroplasty and revision surgery for massive bone defects: a single-center retrospective study
Published 2025-01-01“…Results The average surgical duration was 183.9 minutes (range, 125–240 minutes), with intraoperative blood loss of 133.3 mL (range, 100–200 mL). The average hospital stay was 18.2 days (range, 10–42 days), and the follow-up duration was 13.2 months (range, 2–57 months). …”
Get full text
Article